Repair and diagnostics of engine cylinders

Cars

The cylinder is an important component of the engine,since it is in this node that the conversion of thermal energy into mechanical energy takes place. The cylinder is a combustion chamber for a fuel mixture of gasoline and air or other fuel, depending on the type of engine. By how much the cylinder is subject to high loads and temperature conditions, its operation takes place in harsh conditions.

Therefore it is very important to keep working capacityeach of the engine cylinders. The main malfunctions, as well as defects due to which there is a replacement or repair of the engine block, namely the boring of the cylinders and the installation of repair dimensions of the pistons. But if you have a diesel engine, we recommend contacting a service center whose specialization repair of diesel engines.

As the clearance between the piston and the wall increasescylinder there is a loss of power, as there is a drop in engine compression, which is fraught with large consequences. Due to the drop in engine compression, there is a drop in torque, as well as the crankshaft rpm on certain fuel supplies.

Repair or elimination of these deficiencies - usuallyproduce a bore of cylinders with the installation of repair pistons of a larger diameter. After that, the engine also undergoes running-in and lapping during this run-in.

For removal and boring of cylinders it is necessary forbegan to remove the head of the engine block with the decompression mechanism, after removing the cover of the engine block. Unscrew the nuts with the cross wrench to the cross to avoid leakage of the valve cover. Then, the head of the engine block is removed after removing the camshaft drive gear, it can be either the gears itself, the timing belt, or the chain. All work should be done on a cold engine in order to avoid burns. After the head of the engine block is removed, it is necessary to drain the engine lubrication system prior to removal, this is done through the drain neck by unscrewing the engine oil drain plug on the bottom of the crankcase.

After the oil is drained, it is necessary to removeThe head of the unit with all its elements of the decompression mechanism. Then unscrew the crankcase of the engine. Fastenings in it are directly on the engine block from below, therefore, it is necessary not to damage the tightness of the crankcase gasket carefully to remove the oil pan. Then remove the covers of the connecting rods by unscrewing them without damaging the connecting rod liner. They are unscrewed directly from the bottom, like the oil pan.

Then the connecting rods are pulled out together with the pistons, then the crankshaft is removed. Unscrewing the main bearings. Next, remove the engine block from the engine mount.

Boring is made on special milling and locksmith equipment directly on the machines. Then all this is ground, the walls of the cylinders are polished directly.

Further after the completion of the work all in the sameorder is set, only the installation of all the node is made with a torque wrench, namely the installation of connecting rods, crankshaft, cylinder head, which is twisted cross to the cross so as not to overtight, so a torque wrench is used.

After all the operation, oil is also poured in and the engine compression is checked

Comments (0)
Add a comment